DINESH RATHI GROUP OF COMPANIES
CABLE TERMINAL & LUGS
Entire ranges of copper tubular terminals are made from ETP grade & EC grade aluminum tubes. Terminals are exclusively designed for study performance even on adverse conditions. Unique type test are conducted as per IS: 8909 & IS: 8337.
The range of the terminals & connectors starts from 0.5mm 2 to 1000mm 2 with many variations suiting to many industries.
HAZARDOUS AREA GLANDS
Quality is extremely important in an electrical system. It is maintained by undertaking stage wise inspection, which is always mandatory. Full fledge in house lab. Inspects raw material & out going finished products as per defined rejection / acceptance methods. Relevant Indian & International standards are maintained by concurrent inspections & close monitoring of quality standards. This will enable the customers to select the terminals as per the specification required.
|TYPE OF TERMINALS
|Tubular type terminals ends
||Widely used series for soldering or solder less crimping application made from Cu & Al. Standards followed are IS, BS & DIN
|Ring tongue terminals ends
||Generally used along with control cables. Various shapes can be made & stud holes as per requirement can be made.
|Reducer type terminals ends
||This series is recommended for usage in fuse gears, ICTP switches, watt meters etc.
|Pin type terminals ends
||Termination in terminal blocks is being done with pin type terminal ends. Widely used in control panel wiring. Non-insulated, insulated & pre-insulated versions are available.
|Fork Type terminal ends
||Fixing arrangement of LV / MV switch gears of different varies & hence to suit those application forks type terminal ends are designed.
|In Line Connectors
||For enabling straight through joints of aluminum or copper cables in line connectors are widely used.